Name: 手動ブーストコントローラー取り付け（その2内部アクチュエーター (Manual Boost Controller Install (part 2 internal actuator))
Uploaded: 2021-01-14T07:38:12.000Z
Duration: 2 min 35 s
Description: VoiceTubeの動画で発音を聞きながら英語表現を覚えよう！学べる英語：

様態の副詞

We are actually going to continue the manual boost controller installed on an internal actuator setup

So we're using a manual bicycle pump again to simulate

Positive pressure aka both that would come [from] your turbo compressor. So what we have here know is

[to] the Gauge the boost gauge, then we run a tee fitting now to the actual actuator

You'll see it start to open roughly around [7] PSI and start to come off it see

And you can watch it again pop around 7:00 and start to come off [his] see

okay, so she's pretty much fully open at 7:00, so

The Spring Written in here is fog around [7:00] PSI. Which is what a factory?

So, but this is the correct way to install a manual host controller on an internal actuator

We still have the compressed line the compressed liner will go from here, [so] [we] would t this

this line no would go to the actuator and the

Line would go to the south end this would leave open to atmosphere, or you could actually put another line on here

Depends on the location where you want to install it for this demonstration. We just want to leave it open

So you can see it's going to bleed some pressure off

Yep, and let's tighten this up now and see

how we increase some boosts, so I'm just going to screw this in a few clicks and

as you can see now it's a lot more pressure it takes [to] open the

effectively, you just increase your boost [with] a manual boost controller for about 40 bucks and

Very simple way to do it. Thank you guys for watching Hope you guys found this video informative

Please feel free to leave any feedback in the comments below and as always stay tuned

字幕リスト動画再生

手動ブーストコントローラー取り付け（その2内部アクチュエーター (Manual Boost Controller Install (part 2 internal actuator))

boost

positive

atmosphere

roughly