Name: 車のアクスルシールの交換方法 (How to Replace Axle Seal in Your Car)
Uploaded: 2021-01-14T07:37:45.000Z
Duration: 3 min 53 s
Description: VoiceTubeの動画で発音を聞きながら英語表現を覚えよう！学べる英語：

today I'm going to show you how to replace a

leaking axle seal on your car, now once we took the rear wheel off this Jeep, we

can see there's all kinds of grease on
the backing, that's because the seal

inside here is leaking, and we have to
replace it,

well since the brake calipers in your
way, first we have to take it out of the

way, by taking the two bolts off that are on
the inside, now these are often on super

tight, so get yourself a nice long
cheater bar and a socket, and then pull

like mad, then you can get the two
bolts off, then the brake caliper just

taps off, and the brake rotor slides off,
now we have to take the axle assembly

off, there's four bolts that hold it in,
and they're hiding on the backside in

here, we just take the four bolts off, you
just unbolt them all from the inside,

there's four of them, and there's the
last one,

and now comes the hard part, we have to
get the hub out, and you need a slide

hammer, now you can buy one, rent one at places
like autozone will even loan you one free if you

buy the seals from them, you just stick
the end of it on here, put three of the

lug nuts on, just need on snug,
then you just whack the slide hammer

until the axle comes out, out it comes now,
in most car designs,

the seal is inside the shaft, right in
here,

but of course, jeep has to have a stupid
design, their seal is right here, behind

axle bearings, so now we got to take all
this apart, and buy new axle bearing just

to change the seal, so they turn
something that used to be about a

15-minute job, into one that's going to
take hours, and you're going to have to buy

a bearing, and a seal, because it's going to
ruin the bearing when we take it off to

get to the seal, great engineering there, and now comes the fun, we get to

grind the old  bearing off to get the new
one on, to get the seal behind it, the off

comes the ring, that holds it in place, and
you have to hit the end of the bearing

off, slide that out of the way, and then slide everything else off, just to get
to the stupid seal, then you get the new

seal on the plate, get the plate on, the seal on
here, then you slide the bearing on,

you get the bearing collar and slide the
bearing collar on, now you got a choice ,you

can use the Machine press if you have
one, but just a big piece of pipe to

slide over the top,
we are going to use a pipe,

then we get a big hammer, and tap the
plate, until the bearing slides back in

place, then you slide the axle back in,
and wiggle it until it goes in place, then you

tighten the four backing nuts, then get
some cleaner and spray all the grease

off that's leaked all over the place, put the
brake disk back on, then bolt the brake

caliper back on,
bolt the wheel on, and don't forget to

fill the rear end back up with fluid for
the stuff that leaked out, just take out

the drain bolt and fill it up until
fluid leaks out of there, all that work

just to change this little seal,
engineer's could have built it a lot better

than this, and remember if you have any
car questions just visit the Scotty

Kilmer channel and I'll answer them as soon as I'm
done opening this coconut