Placeholder Image

字幕表 動画を再生する

  • Hello colleagues in my channel

  • today I will drive the car to a workshop for my front wheels alignment

  • Yes but no

  • I'll do it myself

  • any of you may know it

  • from internet

  • for those who do not know it

  • I'll show you how it works

  • first level the steering wheel to the middle

  • go into the car and steer the steering wheel

  • then

  • do you see

  • what are you talking about

  • you see the string

  • stretch it

  • must be equal to the rear rim

  • I will show you

  • with what you have at hand, it is important to measure

  • a little more needs to move

  • adjust until it is equal to both ends

  • make it identical at both ends of the rear rim

  • Move left to right until it is equal to both ends

  • it touches lightly

  • it is made in a place protected from wind

  • need to move a little

  • I've tied it to this tube

  • you are measuring again

  • Done!

  • first starting from the left end

  • because I already did, now I only show you

  • watch it be the same on the front wheel

  • equal to the rear wheels

  • a difference of 0.5 mm is allowed

  • already did

  • unscrew the nut and move slightly until it is level

  • spraying with WD-40, waiting a little and unscrewng

  • Done!

  • check several times

  • the method works

  • perfect!

  • if it is not

  • you get under the car

  • unscrew the nut

  • I put a bracket on it because I'm afraid of going away

  • unscrew the nut underneath it

  • you will not have it, the nut will be visible

  • in my case had to unscrew

  • is normal thread

  • I already did, just show you how it works

  • the bolt unscrew a bit difficult, but it is not impossible

  • hold with the key what's on the tire side

  • if necessary remove the tire

  • I propped one of the wrenches

  • and with a jack I picked up the other wrench until it unscrew

  • you make front wheel to be equal to the back wheel

  • at both ends, starting from the left

  • the string must be at the middle of the rim

  • you measure from both ends of the rear rim to be the same and then the front should be equal again at both ends

Hello colleagues in my channel

字幕と単語

動画の操作 ここで「動画」の調整と「字幕」の表示を設定することができます

B1 中級

ひもを使ったDIYフロントホイールアライメント (DIY Front Wheels Alignment Using String)

  • 34 0
    許小龍 に公開 2021 年 01 月 14 日
動画の中の単語