Left oem slip-on is easy to remove

Unscrew mount bolt and clamp bolt

Install two brothers slip-on

First tighten VALVE, after canister clamp and pipe clamp

On the right side you have to disconnect Exup system

Servo motor is under the seat

Disconnection of exup doesn’t cause any error on this model

Install two brothers slip-on

First tighten VALVE,

after canister clamp and pipe clamp

To plug in juice box you should remove tank and air box

Remove side fairings

Before removing the tank disconnect all wires and hose

To remove air box disconnect sensors

Loosen the clamps on the flaps

Unscrew mount bolt

Disconnect all hoses

Unplug the stock wiring harness from each of the four injectors

Route the harness towards the front of the bike along the left hand frame tube

Attach the Juice Box Pro connectors to each injector and connect black and stock connectors

The sequence of the connection can not be confused, because all connectors have different lengths for a specific injector

Thus the controller cuts between the injectors and the stock wiring

Similarly connect throttle sensor

Attach the ground wire from the Juice Box Pro to the common stock ground wire

After juice box installation should not be any errors

Going in reverse order

Choose the map in juice box

In this case it’s second map for two brothers slip on and OEM air filter

Two brothers slip ons look nice, have good sound and increase power

Subscribe if information was interesting!