Name: 825] ディスクデテーナーピックビルド（第3弾）〜ボスニアンビル特集 ([825] Disc Detainer Pick Build (Part 3) - Featuring BosnianBill)
Uploaded: 2021-01-14T10:33:27.000Z
Duration: 5 min 50 s
Description: VoiceTubeの動画で発音を聞きながら英語表現を覚えよう！学べる英語：

to 不定詞

This is the lock picking lawyer and welcome to part three of our video, Siri's Where with Bosnian Bill, we are building a disc detainer lock pick.

現在進行形

未来形

The tensioning knows which is going to provide a few challenges.

The first is that we can't build this out of brass.

In the past, I have tried building them out of stainless steel and that turned out to be too soft.

So what I was thinking is we can make this out of tool steel.

I have some downstairs that is a kneeled.

You can do all of our miss sheeting and then harden it.

I've had a lot of failures with I mean, you think stainless steel is as tough as woodpecker lips, But when you start making these thin little prongs and applying talk to them, they tend to bend and break fairly easily.

So I think tool steals the perfect choice.

One other thing we discussed that will help make this a little bit stronger, and that is three dimensions.

These little problems, we're going to make them about 3.5 millimetres long.

Now, I have encountered locks in the past that require a little bit more than that, but they're not very common.

So I think making the problem's a little bit shorter will give us that extra bit of length.

Of course, we're gonna have that 20 millimeters of reach that we discussed before and looking at this, this center section we have about 8.5 millimeters of depth that this will reach into the center said, Clamp it in there so it shouldn't be that hard to make.

The only thing I'm concerned about is drilling a really tiny hole all the way through a piece of tool steel.

Why don't we drill roughly half of the way through one side and then flip it over and drilling on the other side?

And when they match up will have a good idea of how closely they're centered to each other.

Let's head down there and give it a shot.

Okay, folks, we are back, and it took a little bit longer than we were expecting.

because this is thesis part we made It turns out, the 1st 1 I got a little bit happy with the hand crank and made that journal that fits inside the center section a little bit too small.

So once we actually got the dimensions right, this came together pretty well.

And after we machined everything out, we hardened and tempered it.

Which, by the way, got Bill kicked out of my house by my wife More than more than kicked out.

It turns out she doesn't like Bill using her toaster too hard to heat treat metal.

Well, that's why we use the back door and I keep your voice down.

So we, uh we made a couple of changes to this as we were going along all the dimensions or what we expected.

That journal and those flats are designed to be engaged by the handles that will go into the center section.

Hopefully hold it steady and also keep it from rotating.

Okay, So the next challenge would be Think the handle the handles.

Thought I thought we decided we're just gonna cut metal.

Let's ask your wife to put some thought into it.

Well, she's the thinker in the family in mind as well.