Name: 電化ピクルス - 動画の周期律表 (Electrified Pickle - Periodic Table of Videos)
Uploaded: 2021-01-14T10:15:30.000Z
Duration: 8 min 23 s
Description: VoiceTubeの動画で発音を聞きながら英語表現を覚えよう！学べる英語：

This is a classic demonstration which involves what I would call a pickled

程度の副詞

gherkin, many of you might just call a pickle. The demonstration involves taking

様態の副詞

two electrically conducting pieces of metal, say forks and sticking them into

each end of the gherkin and then applying a high voltage across it.

Now, I must say immediately this is potentially an extremely dangerous experiment and

one you shouldn't try because if you touch the metal you will get a huge shock.

Neil had a historic piece of apparatus which we used. Unfortunately the plastic

safety cover had been lost, but because we were using it under controlled

conditions, it was safe. I found the piece of equipment about to be thrown out and

I wrote a note to Neil saying: 'save it for periodic videos'. Probably we should go

The first thing to realize is that when you pickle something you put it into a

mixture of salt and vinegar. Salt contains ions, sodium ions, chloride ions

and salt solution is electrically conducting but it's not very

electrically conducting compared to metal. So what you've got, our two

electrical conductors with a resistance in between and when you pass

a current through it, the resistor will heat up.

What you have here and you have to understand that a gherkin is a biological specimen. And biological

specimens are different, so it's not like doing a chemical experiment where the

chemical should be exactly reproducible as you can see this gherkin is

completely different from the other ones, not even as long. So you can't expect

What happens is that when you switch on the current, to begin with,

you see nothing and then at one of the ends and it's important it's at the end

because the maximum resistance appears to be where the fork goes into the

Gherkin, because there's less opportunity for the electricity to be conducted.

That heats up and it heats up enough for the sodium ions to give out light, in the

same way that you may have seen from sodium street lights, now what is

interesting is because mains electricity in most countries is so-called

alternating current, that it switches from positive to negative, positive to

negative. So the polarity switches around going through zero in the UK it's at 50

times a second in the States it's at 60 times a second. And if you watched the

gherkin under high-speed you can see that the light flashes on and off as the

current changes so if you think about the voltage this site is the so-called

neutral which stays at zero volts and this side goes up and down to + 200

volts down minus 200 volts, up and down, and the first time we saw it

there was a strong glow from the neutral end.

And we spent quite a lot of time  thinking, why should it be at the neutral

end, rather than where the voltage is changing. So in the end we thought we'd

just try it again. And the next gherkin it went at the other end, so it's clearly chance.

If you look at the poor gherkin  afterwards, it's a bit shriveled.

And the end where the light came out is charred.

We've actually got hot enough to burn the gherkin. You may know what temperature

So we decided to use a thermal-imaging camera.

The first thing that I noticed is you can see the steam coming out of the

gherkin, because the steam is hot and therefore is picked up by the camera,

whereas our camera barely noticed it in the dark. You can see that it really is

heating up and you can see that the end where the light is coming from gets much

hotter than the other end. We then thought that it would be interesting to

try and increase the resistance of the middle of the gherkin, so Neil cut out a

piece from the middle of the Gherkin like this. Our hypothesis was that if we made

the Gherkin narrow at that point, that part of the Gherkin should get hotter.

Because it's thinner it will conduct the electricity less well, so it has

higher resistance and the heating effect is related to both the current and the

resistance. And the current going through the whole gherkin must be the same, but

the current density will be higher in this small point and it'll get hotter.

And in fact what we found when we looked with the thermal-imaging camera

indeed it did get very hot there. Interestingly even where Neil had

cut it it didn't get hot enough to give any emission from the sodium, but you may

remember we got quite excited why it went at one end rather than the other, and

quite by chance in this experiment what happened was that one end lit up and

then after a bit the other end lit up. For a few moments both were glowing and

then it went to the other end. And you can see really well with the

thermal-imaging camera that the forks themselves, the prongs of the fork, get

very hot. Because they're conducting away the heat from this hot zone.

I have no idea why it changed from one end to the other.

I'm not an expert on gherkin structure and anyway it's probably pure chance.

But you'd have to do lots and lots more gherkins to be sure, when you look at

these experiments and you can see there are videos of this on youtube, you should

always think what is the science behind it.

They're great demonstrations but so often they're wasted, people just take it

as a joke and don't think about the physics or the chemistry behind it.

Thanks for watching periodic videos, if you'd like to follow us on Twitter or Facebook

and all those kinds of things, there are links in the video description. You can

also support us on Patreon, we really appreciate people that do that. It's a

lot of fun you can even adopt an element if you like. But of course the best thing

you can do is do what you're doing right now, and that's watch our videos.